User Manual
5.15 Video Mode
Select NTSC (North America) or PAL (Europe/Australia) video system.
5.16 Factory Reset
Press [ SEL] button to reset the DVR to factory defaults. The DVR will
reboot and all custom settings (including password) will be restored to default.
Caution: There is no confirmation dialog box for this selection after you
press [
SEL] button.
If you have forgotten your password and would like to reset, press [Pause]
button 10 times to reset DVR to factory default. Then the default password is now:
[CH1] button 6 times.
If you are unable to stop recording, you must unplug the power supply and
remove the HDD, then reboot the DVR and press [Pause] button for 10 times.
Chapter 6: Recording
6.1 Start Recording
Press [ REC] to start recording (as set in 5.7 Schedule Set).
DVR will display system information on screen.
10%
1
EACH REC [M] (T) 2008/07/01 16:22:30
5
4
R
R
R
R
3
2
8
1
To Next Page
Loading...
