FITTED EQUIPMENT
102
Attach cover
Suspend the cover (1) in the bottom bearing
and pivot in (2) until the lock audibly clicks into
place. Check the tight fit by pulling.
Battery change on the auto ignitor
If ignition sparks cannot be heard when
commissioning or only at intervals of more than
one second, the battery needs to be replaced.
Only change the battery with the heating
system switched off. Insert a new battery
before the beginning of each heating season!
Dispose of the old battery correctly!
Only use temperature-resistant (+70°C), leak-
proof mignon batteries (LR 6, AA, AM 3) (part
no. 30030 - 99200); other batteries can cause
function faults!
Remove the case, slide the battery
compartment cover up and change the
battery. Pay attention to positive / negative.
Close the battery compartment again. Put the
case back on.
Note: It is compulsory to remove the battery
and dispose of it correctly before scrapping
the auto ignitor!
Technical data
(Established according to EN 624 or Truma
test conditions)
S 3004 (P), S 5004
Gas type
Liquid gas (propane / butane)
Operating pressure
30mbar (see type plate)
Rated thermal output
S 3004 (P): 3500W
S 5004: 6000W
Gas consumption
S 3004 (P): 30-280 g/h
S 5004: 60-480 g/h
S 3004(P): Q
n
= 4,0 kW (Hs); 290g/h; C
51
; I
3B/P
S 5004(P): Q
n
= 6,8 kW (Hs); 290g/h; C
51
; I
3B/P
Countries of destination
BE, BG, RO, DK, DE, EE, FI, FR, GR, UK, IS,
IE, IT, LV, LT, LU, MT, NL, NO, AT, PL, PT, SE,
CH, SK, SI, ES, CZ, HU, CY
TRUMA S 3004 SPACE HEATER
To Next Page
Loading...
Need help?
General
