Fig. 41
Fig. 42
Fig. 43
• For battery igniter models, set energy
selector switch (1) to position “OFF”. The
appliance is switched off (Fig. 40).
• Switch off MES and AES models by pressing
button (2). Keep button (2) pressed for 3
seconds. The display disappears and the
appliance is fully switched off (Fig. 40).
• Release the locking mechanism of the door
lock by pushing it and shift it to the front.
If the door is shut in this position, a small
gap is nevertheless kept open to prevent
formation of mildew.
• If the refrigerator is to be taken out of service
for an extended period of time, close the
onboard shut-off valve and the cylinder valve.
Winter operation
Fig. 35
1
In winter, check that the ventilation grilles and
the exhaust duct system (1) have not been
blocked by snow, leaves, etc.
Fig. 36
2
When the outside temperature falls below
+10°C, the winter covers should be fitted.
This protects the unit from excessively cold
air which could have adverse effects on the
performance of the unit
Note: You should also attach the winter
covers if the vehicle is taken out of service
for a longer period of time or while it is being
cleaned from the outside.
To Next Page
Loading...
Need help?
General
