II. Parts of the microscope
III. Assembly and set up
Carefully remove the microscope body from the box and set it on a sturdy, flat surface.
Remove the microscope head from the box and secure it to the body with the head
locking screw, using care not to overtighten.
Remove the plastic covers from the eyepiece holders on the microscope's head, then
place eyepieces into the holders. Locate the power cord and attach it to the microscope,
then plug it in. Turn the microscope on by pressing the power button on the back of the
base.
IV. Using the microscope
Turn the microscope on and use the illumination intensity control wheel to set the lamp
on the lowest brightness setting.
3
To Next Page
Loading...
Need help?
General
