Sandfiltersystem Basic 3
2.2 Installation diagram
1. Filter tank
2. Pump
3. Three-way overhead valve
4. From pool (unclean). It is recommended
that a practical closing valve be used for the
pump (mounted on the suction hose between
pool and pump - extra accessory, not included)
5. To the pool (cleaned water). It is recommended that a practical closing valve be installed for the
pool (mounted on the pressure hose between pump and pool - extra accessory, not included)
6. Backwash valve for emptying unclean water from the 3-way valve to the drain.
7. Grey pressing ring in plastic, with clamp for fastening the filter lid to the filter tank.
8. Pressure gauge
9. 2 openings to the UV lighting for the water and/or 3 kW electric water heater.
3. Connecting to power source
Observe: For flexible electrical connection to a power source, HO5RN-F is used (indoors)
or HO7RN-F (outdoors). Minimum diameter 1.5 mm² or similar. For permanent connections
with cables, only plastic-coated NYM cables or cables of similar quality may be used.
NOTE: The power source must always have earth connection and be connected to an HFI/HPFI-
device!
When the filtering system is used outdoors, it needs to be connected to an outdoor power source of
230 V 1 N–AC 50 HZ. The power source must be at least 3.5 m from the edge of the pool and must
always be installed by a qualified electrician.
Swim & Fun Scandinavia – info@swim-fun.com – www.swim-fun.com 5
To Next Page
Loading...
