Swiss Timing MULTISPORTS E-GUN - Stand Alone Operation (Powertime); Independent Operation

E-GUN / StartTime IV
Version 1.1 3481.501.02 Page 9
2.2.2 Stand Alone Operation (PowerTime)
First use ONLY
Set
and to ,.
1. Connect or SMU to GUN / MICRO
2. Connect the cable from PowerTime to START 1.
3. Turn the unit ON by pressing the
key (>0.5sec.).
SMU :
LEDs are tested and Recallers LEDs blink till sport selection is made.
e -GUN: red LED blinks till sport selection is made
4. Select your sport (Athletics, Swimming, Speed Skating or Custom)
After 5 seconds, sport will be automatically selected to your last used.
SMU : ST4 power lamp will light up and red LED SPEAK in the microphone should be lit.
e -GUN: ST4 power lamp will light up
5. Adjust the volume button on the StartTime IV to an appropriate level.
6. Press the TRIGGER (
) or START (SMU) button
7. One signal should sound from the loudspeaker(s), and the TIMER should be activated.
If a false start is to be announced, press the TRIGGER (
) or START (SMU) button
again within time selected in
.
False start signal(s) (
and ) will be heard.
2.2.3 Independent Operation
It is possible to use the StartTime IV without
or SMU.
In this case, it is only possible to carry out starts and false starts with the "START" button of the
ST4
First use ONLY
Set
and to ,.
1. Turn the unit ON by pressing the
key (>0.5sec.).
2. Press the
key for the start.
3. If a false start is to be announced, press the
key again within time selected in
and several signals will be heard (Depending on and
selection).