Swiss Timing MULTISPORTS E-GUN - Ready 1 Needed (Main; Primary); Ready 2 Needed (Backup; Secondary); Recaller Mode; Auto Ready

E-GUN / StartTime IV
Version 1.1 3481.501.02 Page 13
3.4.6 Ready 1 Needed (Main / Primary)
If you want to authorize start from the Main/Primary TIMER installation (control room), select the
setup to
.
The system, when connected to timing devices such as Quantum, Chronos or ARES, gives a high
level of security with the READY indicator.
That is to say it may be deactivated from the Control Room if the Timing Technician is not ready to
accept a start signal
3.4.7
Ready 2 needed (Backup / Secondary)
If you want to authorize start from the Backup/Secondary TIMER installation (control room), select
the setup to .
The system, when connected to timing devices such as Quantum, Chronos or ARES, gives a high
level of security with the READY indicator.
That is to say it may be deactivated from the Control Room if the Timing Technician is not ready to
accept a start signal
3.4.8
Recaller mode
Recallers units are used if help starters are authorized to announce false start, If you have
recallers units, select
.
3.4.9
Auto Ready
Time in seconds (1-60) where starter or recallers are authorized to give a false start after a start.
If you do not need this set up, you can select the
value.
3.4.10
False Signals
Define number of false start signal (
- ) generated when a false start is activated.
3.4.11
Standby
Value in minutes of automatic Standby if StartTime IV is not used.
The system authorizes a start in standby mode.
If you do not need this set up, you can select the value.
3.4.12
Power off
Value in minutes of automatic Power off if StartTime IV is not used.
If you do not need this set up, you can select the
value.