EN - 43
EN
HEADLIGHT BULB REPLACEMENT
The headlight (1) is of LED type.
In case of fault, contact and SWM dealer.
TAIL LIGHT BULB REPLACEMENT
The tail light (2) is of LED type.
In case of fault, contact and SWM dealer.
PLATE LIGHT BULB REPLACEMENT
To replace the plate light, proceed as follows:
- remove the plate by releasing it from the side
fastening devices;
- disassemble the plate by removing the screws (3)
and their nuts (5);
- unscrew and remove screws (1) and (6);
WARNING
Do not unscrew screws (2) and (4).
2
3
4
5
- lift the cover (7) and remove the lamp holder (8);
- replace the W5W lamp with a new one, removing it
from its lamp holder.
For retting, repeat the operations described in reverse
order.
1
6
7
8
To Next Page
Loading...
