SX mini G2 - Troubleshoot

31
V1.97



 
 

Not detecting coil
• Install an atomizer
• Check 510 connection


Either the atomizer is not
connected. or the unit has
detected a problem
• Examine atomizer
 Ω
 
Resistance is higher than
3.0Ω
• Change to supported coil
 Ω
 
Resistance is lower than
0.05Ω
• Change to supported coil


The Atomizer is shorting
• Examine atomizer
• Examine coil


Batteries have 5% left
• Prepare to charge
batteries


Batteries have 0% left • Charge your Batteries


The internal board is
overheating
• Wait for it to cool down
• Contact support


Battery Overload Detected
(Calculated AMPS are higher
than congured CDR)
• Optional: Set your correct
battery CDR in MAIN-
MENU→TWEAKS
or shut it off.


Batteries behave
abnormally
• Check batteries
• Replace batteries
   

The coil/wire cannot be
used in Temp-Control Mode
• Use supported TC wires


Temp-Control Dry Hit
Protection
• Add liquid
• Check locked resistance
• Make sure to lock Ω at
room temp
  Power is being cut off
• Check MAIN-
MENU→TWEAKS to adjust
cut off time