Sylvac S_Dial WORK ANALOG Smart User Manual

MODE
MODE
SET
10
E
.......Input the lower tolerance limit
.......Input the upper tolerance limit
next digit 0...9 save PRESET
5. Inputting tolerance limits
To input or modify the tolerance limits, tol → On mode should be selected, followed by a short press on :
Note :
- For measuring internal dimensions, the red and yellow indicators can be switched over by reversing the order in which
the tolerance limits are input (lower limit > upper limit).
- It is possible to input different tolerances on REF1 and REF2.

Sylvac S_Dial WORK ANALOG Smart Specifications

General

Brand	Sylvac
Model	S_Dial WORK ANALOG Smart
Category	Measuring Instruments
Language	English