Sym Allo 50 - Ignition Switch and Steering Lock Operation; Seat Open and Button Controls

7
§OPERATION OF IGNITION SWITCH §
“ON” position:
 Engine can be started in this position.
 Ignition switch key can not be removed.
“OFF” position:
 Engine is shut off and can not be started in this
position .
 Ignition switch key can be removed.
§OPERATION OF STEERING HANDLE LOCK SWITCH §
“Steering handle lock” position
 Turn the steering handle to left and insert the key
into, press ignition switch key clockwise and then
lightly turn it to left to the “lock” position.
 The steering handle is locked in this position.
 Ignition switch key can be removed.
 When unlocking, simply turn the key from the
“LOCK” position to the “OFF” position.
§OPERATION OF SEAT OPEN SWITCH§
 Inserted the ignition switch key in the main switch lock.
 Turn the ignition switch key to the“seat open” position counter-clockwise.
 Then, the seat will be open.
§USE OF BUTTONS §
I
G
N
I
T
I
O
N
S
W
I
T
C
H
CAUTION:
 Never operate the ignition switch key when the motorcycle is running. To turn the ignition
switch to “OFF” and “LOCK” position will shut off the electrical system and that may result in a
dangerous accident. Therefore, the ignition switch can only be turned off after the motorcycle
has been completely stopped.
 Always remove the key and be sure to take the key away with you after locking the steering
handle before leaving your motorcycle.
 If ignition switch remains in the “ON” position for a prolonged period after the engine has been
stopped, the battery’s capacity will be reduced and this may affect the engine’s start ability.
 Make sure to take the key away with you before you lock your seat.
Turn Signal
Switch
Horn Switch
High/low
beam switch
Seat open
Electrical starter
button
IGNITION SWITCH
CAUTION:
 Make sure to take the
key away with you
before you lock your
seat.