7. Use of each component
10
• High/Low Beam Switch
This is the high and low beam of headlight switching switch. Press this switch to switch between high
and low beams.
This is for high beam.
This is for low beam. (Please turn to low beam when riding in city)
• Passing Switch
Turn ignition switch “ ” and press this button down. Then, the high beam of headlight will
come on immediately to warn the driver of the vehicle ahead that you intend to overtake
him/her. (For overtaking, high beam indicator will come on at this time) This button will return
to original position after releasing.
• Horn Switch
Press this button down when ignition switch is in
the “ ” position to sound, the horn.
• Turn Signal Switch
Turn signal lights are used when turning left/right or changing lane.
Turn ignition switch to “ ”, and slide the turn signal switch to left or right. Then, the turn signal lights will
flash.
To release, simply return the turn signal light button to the original position.
Right-side turn signal light flashing means you intend to make a right turn.
Left-side turn signal light flashing means you intend to make a left turn.
•
POWER SUPPLY COMP
The accessory socket is inside the inner
box .You can use the accessory socket to
power a trouble light, PDA, spotlight, radio,
or cell phone, etc.
CAUTION:
Do not plug in any head-generating accessory such as an automobile cigarette lighter because it
can damage the socket.
Do not use the socket in raining day.
Do not splash water or other liquid on socket when using the socket.
To use accessory socket, turn the ignition switch to start the engine. Then turn the headlights ,
and open the accessory socket cap.
The accessory socket’s rated capacity is DC 12V, Max 60Watts (5A) and below long-term usage 4 hours.
NOTICE:
Do not press the horn button when
you are in the no horn area.
To Next Page
Loading...
Need help?
General
