1. General Information
1-8
y Do not let the wire harness been twisted as
installation.
y Wire harnesses routed along the handlebar
should not be pulled too tight or have excessive
slack, be rubbed against or interfere with
adjacent or surrounding parts in all steering
positions.
y Before operating a test instrument, operator
should read the operation manual of the
instrument. And then, conduct test in
accordance with the instruction.
y With sand paper to clean rust on connector
pins/terminals if found. And then conduct
connection operation later.
Do you know how to set the
instrument to its
measurement position and
the insert locations of its
two probes?
Clean rust
To this chapter contents
To Next Page
Loading...
