5. Removal & Installation of Engine
5-2
Operational Precautions
General Information
y Engine must be supported by a bracket or adjustable tool in height.
y The following parts can be serviced with the engine installed on the frame.
1. Carburetor
2. Driving disk, driving belt, clutch, and transporting disk
3. Final reduction gear mechanism
Specification
Specification
Item
MIO 50 MIO 100
Replacement 700 c.c. 650 c.c.
Engine Oil Capacity
Disassemble 800 c.c. 750 c.c.
Replacement 90 c.c. 100 c.c.
Gear Oil Capacity
Disassemble 100 c.c. 110 c.c.
Torque Values
Engine hanger bolt (frame side) 4.5~5.5kgf-m
Engine hanger nut (engine side) 4.5~5.5kgf-m
Bolt of rear cushion upper connection 3.5~4.5kgf-m
Bolt of rear cushion lower connection 2.4~3.0kgf-m
To this chapter contents
To Next Page
Loading...
