-7-
3. Balance Calibration:
6. Obstacle avoidance function:
Notice: Fully charged drone battery will ensure the best 3D stunts performance.
Note:
1. White objects are best. (There is no
obstacle avoidance function in high speed mode)
2. In order to avoid malfunction of infrared interference,
please do not operate two aircraft at the same time within 5 meters.
Place the drone on a flat level surface and after,
push both sticks to the lowest right corners and hold
them there for 2 to 3 seconds. The drone indicator
lights will start flashing quickly. Wait until the drone
indicator lights stop flashing and turn solid again
(glow) indicating successful balance calibration.
4. Low/High Speed Mode:
Low speed mode is the default mode. To change
the speed mode gently press the right stick once,
the transmitter will emit two beeps indicating high
speed mode. Gently press the right stick again and
the transmitter will emit one beep indicating low
speed mode.
5. 3D Stunts:
After the basic operational skills are mastered, you
can start performing 3D stunts with high speed
mode, After reaching a certain height. Press the 3D
stunt button (top right button on the transmitter) and
at the same time push the directional stick
completely forward / backward / left / right. The
drone will perform forward/backward/left/right 3D
stunt.
Obstacle avoidance conditions and requirements:
a.The drone must be in the slow mode to achieve the obstacle avoidance
function.
b.You must avoid using the function outdoors or infra-red interference, such as
poor obstacle avoidance under strong sunlight or infrared light or even loss of
obstacle avoidance.
c. In the face of glass objects or dark objects, the drone has poor obstacle
avoidance effect and even loses the obstacle avoidance function. The
obstacle avoidance effect in front of light objects can be better reflected.
d. If the drone is flying close to the ceiling,
the drone will lose control.
To Next Page
Loading...
