SYMEO LPR-1D24 - 7.5.1 Device - Application Settings - Customer Protocol; 7.5.2 Device - Application Settings - General; Figure 19 - Device: Application Settings; Figure 20 - Device: Application Settings - Costumer Protocol Settings

SYMEO Local Positioning Radar System
LPR®-1D24
LPR®-1D24 Station – Overview and Mounting
Web User Interface for LPR®-1D24
Copyright © SYMEO GmbH 2015
LPR-1D24_Users_Manual_FCC-IC-Edition_EN.docx Page 27 of 34
Figure 19 – Device: Application Settings
7.5.1 Device - Application Settings – Customer Protocol
With this function (see picture below) you chose to:
 set the Protocol frame length
 set the Protocol TCP port
 define the Output interval of customer protocol
Figure 20 – Device: Application Settings - Costumer Protocol Settings
7.5.2 Device - Application Settings – General
With this function (see picture below) you can set the LPR
®
-1D24 settings:
 LPR group ID
o Group identifier of one pair of LPR
®
units, associated together. Has to be the same on
units measuring with each other. Diverse measurement paths must also be adjusted
to different group IDs.