EasyManuals Logo

Symmetricom Time Server User Manual

Symmetricom Time Server
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
3-40 TimeVault™ User’s Manual 6000-100Ch3.fm Rev. D
Chapter 3: Remote Operation Telnet Access
3.2 Telnet Access
TimeVault can perform setup and control operations sent from a remote location through
the Internet. The protocol used for Internet access to TimeVault is Telnet, a standard
Internet communications program, with an ASCII character-based interface, that is
bundled with Windows 95/98/NT and connects to TimeVault’s NET Port. Use Telnet just
like Procomm, or any other serial interface program, by entering F-series commands, to
which TimeVault responds.
The Utility Port takes precedence over the Telnet session. If the Utility Port is active,
either Telnet login will fail or, if already logged in, trying to send any Telnet command
generates the response:
NOTICE: Cannot respond to command because Utility Port
session has priority.
Telnet sessions have a 15 minute session timer. If there is no activity on the Telnet
session, the timer automatically terminates the session.
3.2.1 Starting Telnet and Making a Connection
1. Press Start on the task bar in the lower left corner of your screen.
2. Click Run and enter Telnet in the Open field.
The Run dialog box appears:
3. Click OK.
The Telnet – (None) window appears:
The following section only applies to Microsoft Windows users. If you are using an operating
system other than Windows (such as Macintosh or UNIX), check with your System
Administrator for Telnet application information.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom Time Server and is the answer not in the manual?

Symmetricom Time Server Specifications

General IconGeneral
BrandSymmetricom
ModelTime Server
CategoryNetwork Card
LanguageEnglish