4-86 TimeVault™ User’s Manual 6000-100Ch4.fm Rev. D
Chapter 4: Serial or Telnet I/O Functions Login/Logout
4.5 Login/Logout
There are two levels of login: “operator” and “guest”.
4.5.1 Operator Login
Use the Operator login to run function requests and entries, change settings and perform
software updates. As shipped, and whenever the unit is started in BootLoader Mode, you
can access the Operator level with:
•User Name: operator
• Password: mercury
To maintain security, change the Operator password at installation.
If you are logged in as “operator”, the only serial or Telnet function that you cannot
perform is to change the Guest password.
4.5.2 Guest Login
Use the guest login to view function requests. As shipped, you can access the Guest level
with:
•User Name: guest
• Password: truetime
To maintain security, change the Guest password at installation.
If you try to use a function that is not accessible from the guest login, you will see a
message such as
Access denied
or
Command canceled.
4.5.3 Logout
You can logout using any of the standard logout commands, as follows:
• logout
• logoff
• exit
• quit
To Next Page
Loading...
Need help?
General