Need help?Do you have a question about the Symmetricom Time Server and is the answer not in the manual?
General| Brand | Symmetricom |
|---|---|
| Model | Time Server |
| Category | Network Card |
| Language | English |
Statement of compliance with FCC Part 15 Subpart B and ICES-003 Class B limits.
Device operates under Part 15 of FCC rules, subject to two conditions for interference.
Declares conformance to EU directives for Safety (Low Voltage) and EMC.
Covers initial site requirements and preparations for unit installation.
Step-by-step guide for securely mounting the TimeVault in a rack system.
Lists required hardware for initial setup, including power, antenna, and network connections.
Details the unit's boot process, synchronization modes (GPS, ACTS, NTP), and rolling redundancy.
Guides first-time configuration of IP address, subnet mask, gateway, and DHCP.
Introduces remote setup and control via web browser using HTTP or Telnet protocols.
Details how to edit ACTS, NTP, and SNMP parameters via the web interface.
Covers remote setup and control via Telnet, including connection and session management.
Explains serial communication via the Utility Port and using HyperTerminal for access.
Introduces F100 commands for advanced network parameter and function configuration.
Lists and explains various error codes, their meanings, and recovery actions.
Details SNMP security, community settings, and configurable parameters.
To Next Page