To Next PageTo Next PageHow to clean spotting finish on Symmons Sereno Trim TA-10 T-12A S4300TRMTC Plumbing Product?
If the finish of your Symmons Plumbing Product is spotting, it could be due to elements in your water supply causing water stains. To resolve this, clean the finished trim area with a soft cloth, using mild soap and water or a non-abrasive cleaner. Quickly rinse with water afterward.
General| Brand | Symmons |
|---|---|
| Model | Sereno Trim TA-10 T-12A S4300TRMTC |
| Category | Plumbing Product |
| Language | English |
Lists available trim-only model numbers for the Sereno Trim Series.
Lists model numbers for trims with TA-10 Flow Control Spindle and T-12A Cap Assembly.
Specifies compliance with ASME A112.18.1/CSA B125.1 standards.
Details warranty for original end purchasers in consumer/residential installations.
Details warranty for industrial/commercial installations.
Lists replacement parts (Cap Assy., Flow Control Spindle) for TRMTC models.
Steps to remove the test cap and install trim for TRMTC models.
Procedure to adjust the packing nut for handle resistance.
How to set the temperature limit stop screw to prevent excessive hot water.
Lists parts for showerhead (A-C) and tub spout (M).
Lists parts for valve trim (D-K) and handles (L, N).
Lists parts for hose (V), wall elbow (U), and flange (T).
Step-by-step guide for installing the shower valve trim components.
Instructions for attaching the showerhead to the shower arm.
Instructions for attaching the tub spout to the pipe.
Steps for installing the slide bar mounting plate.
Steps for attaching the cradle arm, hose, and hand shower.
How to adjust the handle for cold, warm, and hot water positions.
How to operate the diverter to switch water flow between tub spout and shower.
How to increase or decrease water volume using the control handle.
Cause and solution for finish spotting due to water staining.
