SYNAPTICON SOMANET Node 400 Hardware Manual

1.4 Installation Guide
This manual will guide you through the basic steps to get your SOMANET Node 400/1000/2000
EtherCAT running.
Attention
When dealing with electronic devices, always consider these handling instructions!
Important
For proper functionality of the current sensors the servo drive must not be exposed to external
magnetic fields, see our mounting instructions for details.
Wiring instructions
Power supply, phases and brake
Encoders and IO
Connector types and mating parts numbers
Mounting instructions
On-site installation guide (UL)
After you have successfully set up your servo drive you can proceed to commission and tune your drive:
Commissioning and tuning with OBLAC Drives
Hardware Manuals / SOMANET Node / SOMANET Node rev. E.1
© 2021 Synapticon GmbH | Daimlerstraße 26 | D-71101 Schönaich Documentation v 4.10.2 | Built 2021-07-06 14/67

SYNAPTICON SOMANET Node 400 Specifications

General

Brand	SYNAPTICON
Model	SOMANET Node 400
Category	Servo Drives
Language	English