Synco Mic-M2S User Manual

Thank you for choosing SYNCO product.
Please read this manual carefully before use and follow all instructions mentioned
herein.
Microphone Mic-M2S
User Manual
Caring For Your SYNCO Product
Please keep the product in a dry, clean, dust-free environment.
Keep corrosive chemicals, liquids and heat source away from the product to
prevent mechanics damage.
Use only a soft and dry cloth for cleaning the product.
Malfunction may be caused by dropping, impact of external force.
Do not attempt to disassemble the product. Doing so voids warranty.
Please have the product checked or repaired by authorized technicians if any
malfunctions happened.
Remove the battery for long time storage.
Failure to follow all the instructions may result in mechanics damage.
Warranty does not apply to human errors.
1. The Use of Wind Mu󽗈
Operations
Please install the wind mu󽗈 to the microphone for wind noise suppression.
2. The Use of Microphone
1) Attach the shock mount to your
device via the cold shoe or 1/4” screw
hole on the bottom of the shock mount.
2) Mount the microphone onto the shock
mount, and connect the microphone with
your device via the 3.5mm TRS camera cable
or the 3.5mm TRRS phone cable.
4. Battery Replacement
SYNCO Mic-M2S uses a replaceable AAA battery. Please install or replace the
battery as shown below.
3. Indicator Instruction
3) Turn on the microphone and run the audio/video recording application in
your device.
Indicator
Microphone Status
Green
Power On
Blue
Low-cut Function On
Speci󽗉cations
1. Polar Pattern: Cardioid

Synco Mic-M2S Specifications

General

Polar Pattern	Cardioid
Frequency Response	20 Hz - 20 kHz
Connector	3.5mm TRS
Sensitivity	-32dB ± 3dB (0dB=1V/Pa at 1kHz)
Power Supply	Plug-in Power
Max SPL	120dB
Type	Condenser Microphone