Thank you for choosing SYNCO product.
Please read this manual carefully before use and follow all instructions mentioned
herein.
Microphone G1(A1)
User Manual
Caring For Your SYNCO Product
Please keep the product in a dry, clean, dust-free environment.
Keep corrosive chemicals, liquids and heat source away from the product to
prevent mechanics damage.
Use only a soft and dry cloth for cleaning the product.
Malfunction may be caused by dropping, impact of external force.
Do not attempt to disassemble the product. Doing so voids warranty.
Please have the product checked or repaired by authorized technicians if any
malfunctions happened.
Failure to follow all the instructions may result in mechanics damage.
Warranty does not apply to human errors.
1.Power Button
Long press the power button for 2 seconds to turn on/o the system.
2.Pairing
The system will pair automatically after power on. If you need manual
pairing, long press the pairing button on the RX and TX for 3 seconds, the
system will start to pair.
3.Connection
The receiver outputs audio signals to recording devices with a 3.5mm
TRRS Phone Cable or a 3.5mm TRS Camera Cable. Please use the
corresponding cable based on your device.
4.Installation
Attach the transmitter or the external mic to the speaker’s clothing. Install
the receiver to the camera’s hot shoe via the pocket clip.
(Note: When using the external mic, please insert it into the mic input
properly.)
Operations
Product Instruction
Package List
Indicator
Slow Flashes
Fast Flashes
Keeps On
Fast ashes twice, is
o and repeats
Power Indicator (Green)
Power is lower than 10%.
/
It stays green when charging
and is o after fully charged.
/
Pairing Indicator (Blue)
Power on
System pairing
System paired
Low cut function is on.
TX Transmitter
RX Receiver
① External Mic Input
② USB-C Port
③ Power
④ Reset(Help with Eject Pin)
⑤ Low Cut
① USB-C Port
② Power
③ Reset(Help with Eject Pin)
④ Gain Control
⑤ Pairing
⑥ Pairing
⑦ Built-in Mic
⑧ Pocket Clip
⑨ Pairing Indicator
⑩ Power Indicator
⑥ 3.5mm Audio Output
⑦ 3.5mm Monitoring Jack
⑧ Pocket Clip
⑨ Pairing Indicator
⑩ Power Indicator
5.Gain Control
The initial value of the gain is the microphone’s original volume. Each
press of the gain control button increases the gain by one level, fourth
level at most. When the gain is at max level, press once and return to
initial value.
RX Receiver x1 TX Transmitter x1 Carrying Bag x1
2-in-1 Charging Cable x1
External Lav Mic (With Wind Mu) x1
3.5mm TRRS Phone Cable x1
3.5mm TRS Camera Cable x1
Mic Windshield x1
Eject Pin x1
To Next Page
Need help?
General
