17
Chapter 2: Hardware Setup
To remove the memory module
1
Follow step 1 to 2 of the
"To install the memory module"
section to shut down your Synology NAS,
disconnect the cables and remove the cover.
2
Push the levers on both sides of the memory module outward. The memory module will be released from its
slot.
3
Hold the memory module by its edges and remove it from the slot.
4
Replace the cover and tighten the two screws that removed.
5
Reconnect the cables that removed, then press the power button to turn on your Synology NAS.
To Next Page
Loading...
