Synology DS2422+ - Hardware Setup; Tools and Parts for Component Installation; Install Drives

11
Tools and Parts for Component Installation
Please prepare the following tools and parts before setting up your Synology NAS:
• A screwdriver (only for 2.5" drives)
• At least one 3.5" or 2.5" SATA drive (please visit
www.synology.com/compatibility
for compatible drive
models)
Warning:
If you install a drive that contains data, the system will format the drive and erase all existing data.
Please back up any important data before installation.
Install Drives
1
Press the right part of the hard drive tray to unlock the handle.
DS2422+
2
Pull out the hard drive tray handle as shown below to remove the hard drive tray.
DS2422+
Hardware Setup
2
Chapter