EasyManuals Logo

Synrad Firestar v40 User Manual

Default Icon
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
getting started
19
SYNRAD OEM v40 Operator’s Manual Version 4
Connecting
The Connecting section includes subsections:
Water-cooled connections
OEM air-cooled connections
Electrical connections
Control connections
Water-cooled connections
Note: If your v40 laser is fan-cooled, then skip to the Electrical connections section.
Read Guidelines for cutting and installing tubing before installing any cooling tubing and then make sure to
connect the cooling system exactly as described for your particular laser.
Guidelines for cutting and installing tubing
Cut tubing lengths generously to allow for trimming.
Cut tubing squarely; diagonal cuts may not seal properly. Carefully trim any burrs if the cut is “ragged”.
Avoid excessive stress on ttings; create gentle bends when routing tubing close to connectors.
Excessive stress from sharp bends tubing will compromise the sealing properties of the tting.
Never allow the tubing to kink, since kinking severely restricts coolant ow.
Push tubing completely into the tting, then pull the tubing to verify that it is locked into place.
Tubing extends into the tting approximately 7/8 of an inch.
If tubing must be disconnected from a tting, rst push and hold the tubing slightly into the tting.
Next push the white tting ring evenly towards the tting, and then pull the tubing free.
After disconnecting tubing from a tting, trim 1/2" from its end before reconnecting. Trimming
the end of the tubing before reconnecting the tting provides an undisturbed sealing surface.
Laser cooling ttings
If your integrated laser application uses metric cooling tubing, we recommend the installation of tubing
adaptors to convert the lasers WATER IN and WATER OUT ttings from 1/2-inch tubing to 12-mm met-
ric tubing. These tubing adaptors are available from many tubing and tting manufacturers.
If, for any reason, you must remove and then reinstall the threaded WATER IN and WATER OUT cooling
ttings on the laser, do not overtighten them. When installing new ttings, wrap the threads with teon
tape and then carefully tighten the ttings until they are just snug enough to prevent water leakage.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Synrad Firestar v40 and is the answer not in the manual?

Synrad Firestar v40 Specifications

General IconGeneral
BrandSynrad
ModelFirestar v40
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals