Syntec 60CA - Page 33

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 33
• •
•
f.
•
•
•
•
•
•
g.
•
•
•
•
•
•
•
•
•
•
h.
•
•
•
•
i.
•
•
•
•
•
•
•
•
•
YZ XZ
ZX
Setting quadrant
User can define the quadrant of simulate plane.
Quadrant can define are as below.
First
Second
Third
Fourth
Simulate Mode
Setting profile simulate method.
Simulation
When user go to the 『Monitor』 page, simulation will show up automatically.
System will scan the whole program and detect the simulation boundary, and then
simulation will execute. No need to define the simulate boundary.
Direct Draw
When user go to the 『Monitor』page, cursor will show up but simulation will not
execute automatically.
User need to define the simulation boundary first.
When the machining starts, cursor will follow up as well.
Not Simulation
Close the simulation function.
View Angle Setting
Under XYZ draw mode, by setting this parameter, simulation will show up with 3D
simulation.
View angle can define are as below.
Vertical
Horizontal
Scope
Scope can define are as below.
Minimum
X-Axis
Y-Axis
Z-Axis
Maximum
X-Axis
Y-Axis
Z-Axis