Syntec 60CA - Page 32

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 32
•
•
•
•
•
•
a.
•
b.
•
•
c.
•
•
d.
•
e.
•
•
• •
• •
Simu. Setting
Command
5 buttons type: F2 Program→F5 Simulation→F5 Simu. Setting
8 buttons type: F2 Program→F7 Simulation→F5 Simu. Setting
Function
Setting the relative simulation item.
Simulation parameter
Color
Provide 16 different colors (Setting 0~15).
Path Color
Simulation path color.
Provide 16 different colors (Setting 0~15).
Cursor Color
Color of cursor point
Provide 16 different colors (Setting 0~15).
RGB Value
Except the 16 default color, user can define the color by them self.
Draw Mode
User can define the profile simulate plane.
Plane can define are as below.
XYZ YX
XY ZY