Syntec 60CA - Page 31

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 31
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
8 Buttons type: F2 Program→F7 Simulation→F2 Continue
Function
System will scan all of the programs and then do the simulation.
Zoom
Command
5 Buttons type: F2 Program→F5 Simulation→F3 Zoom
8 Buttons type: F2 Program→F7 Simulation→F3 Zoom
Function
Zoom in/out the simulation window.
Operation Method
Press F3「Zoom」,there will be a block show up. Use【↑】【↓】【←】【→】can move the window up, down,
left and right.
Use【Page Up】【Page Down】to change the zooming area.
Press【ENTER】to check the result.
Graph Reset
Command
5 buttons type: F2 Program→F5 Simulation→F4 Graph Reset
8 buttons type: F2 Program→F7 Simulation→F4 Graph Reset
Function
Reset the simulation result to default.