Syntec 60CA - Auxiliary and Incremental Input

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 40
•
•
•
•
•
•
•
a.
b.
c.
d.
•
a.
b.
c.
d.
e.
•
•
•
•
•
•
a.
b.
c.
d.
•
a.
b.
c.
d.
e.
•
•
•
•
Aux. Coord. Teach
Path
5 key, 8 key：F3 Offset/Setting→F1 Workpiece Coord.→F3 Aux. Coord. Teach
10+8 key：G3 Offset/Setting→ F1 Workpiece Coord.→ F3 Aux. Coord. Teach
Explanation
Set the current cursor located workpiece coordinate value into the corresponding auxiliary
coordinate value.
The Aux. coordinate value only appears after applying middle function.
Operation Method
Apply the middle function to calculate the aux. coordinate value.
Move cursor to the modifying workpiece coordinate
Press 「Aux. Coord. Teach」
Original value of workpiece coordinate will then be replaced by the corresponding Aux.
coordinate value.
Example
Current Aux. coordinate of X axis is 5.000
Current G54 X axis value is 0.000
Move cursor to the G54 X axis coordinate
Press "Aux. Coord. Teach"
The G54 X axis value will then become 5.000
Inc. Input
Path
5 key, 8 key：F3 Offset/Setting→F1 Workpiece Coord.→F4Inc. Input
10+8 key：G3 Offset/Setting→ F1 Workpiece Coord.→F4 Inc. Input
Explanation
Change the cursor located workpiece coordinate value into (cursor located coordinate value +
keyed in teaching value)
Operation Method
Move cursor to the modifying workpiece coordinate.
Input the teaching value.
Press "Inc. Input"
The workpiece coordinate value will then become the value of cursor located coordinate value +
keyed in teaching value.
Example
Current G54 X axis value is 5.000
Move cursor to the G54 X axis coordinate
Input 10.000
Press "Inc. Input"
The G54 X axis value will then become 15.000
Mach. Coord. Inc. Teach
Path
5 key：F3 Offset/Setting→F1 Workpiece Coord.→Next→F1 Mach. Coord. Inc. Teach
8 key：F3 Offset/Setting→F1 Workpiece Coord.→F6 Mach. Coord. Inc. Teach
10+8 key：G3 Offset/Setting→F1 Workpiece Coord. →F6 Mach. Coord. Inc. Teach