Syntec 60CB - Page 101

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 101
•
•
•
•
Function
Provide controller software version
4.10 Parameter (MainFenu: F6)
Under the main menu, press F6 to enter this function as shown in the following figure.

Descriptions of sub functions are as below:
F1：User param
Function：
Drive the parameters of server system, for example: server parameter, mechanism parameter, range of
program stroke, and max. feedrate speed..etc.
Operation：
When system is in manual data input mode (MDI), user should press stop button before setting any
parameter ("unready" shown on the state). Whenever the parameter is changed, system must be restart
to effect the changes.
4.11 Diagnosis (MainFenu: F7)
This selection provides users with direct access to the memory area for parameter checking, parameter settings
and NC diagnosis function. It can also be used to maintain and debug the control devices. Under the main
menu, press F7 to access this function as shown in the following figure.