Syntec 60CB - PLC Parameter Settings

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 61
•
•
•
•
•
•
•
•
a.
b.
c.
d.
e.
f.
4.9.4 PLC Parameter
Path
5 key, 8 key: F5 Maintain → F4 PLC Param.
10+8 key: G5 Maintain→ F4 PLC Param.
Explanation
Syntec controllers provide R81~R100 total 20 registers for machinery to use, each register can be
divided into 16 Bits.
With the 20 register sets, machinery can provide users the control flag of specific PLC functions.
Extended parameters(Pr3401~Pr3420) with value out of the range of 0~65535 are not able to set
its corresponding register in this screen.
Operation Method
Move the cursor with arrow keys【↑】【↓】【←】【→】
Use【PageUp】【PageDown】 to switch pages.
Users can only input 0 or 1.
Users can add comments to each Bit.
Corresponding file name for the comments is ParamExt_RBit_(L).xml
(L) = COM/CHT/CHS/language