机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 11
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Description
All the manipulation for operator can be executed in this page during processing
File Manage
Execute Process as arrange in workinglist
Adjust the sequence and work station (multiple-station machine) of NC files
Log in/out of operator
WorkingList process Monitor
Work Station default set 1 to G54, and 2 to G55
Process state default built-in:
Undone
Aligning
Working
Printing
Done
Contact Syntec Technician if you have request for new process of the state.
Information of Workiniglist shows as:
Sequence NC files Work Station State Repeat Times
1 00001.nc 1 Non Process 1
2 00002.nc 2 Non Process 1
4.4.2 Operator Panel-F2: Change Column
Adjust the sequence of items in workinglist
Select One Item by pressing the button on the left side of workinglist, and there are 2 ways to change the
sequence.
Adjust selected item be forward, the sequence of selected item will be replaced by previous item.
Adjust selected item be later, the sequence of selected item will be replaced by the next item.
Adjust selected item be later
Before
To Next Page
Loading...
Need help?
General
