Syntec 60CB - Page 116

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
How to Operate 60 Series Controller– 116
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
customer need to use this function, please contact to machine maker.
Condition
Both auto and manual can be used.
Operation
Pr.3228 is the on/off control of 「Tool management」
Description
Turret
Current tool case no. that tool located.
Group
Same kind of tool within in one group, if the first tool of that group is on lock state or 「Tool
life」is end, whenever user use T code to change the tool, system will skip the first tool and
use the second one, when the second one is lock or「Tool life」is end, will use the third one,
and so on.
Tool information (Status)
L—Lock / U—Unlock
If the status of tool is lock, that tool cann't be use and when T code is use to change the
tool, system will skip that tool.
B—Large diameter Tool/ N—Normal Diameter Tool
Adjacent side of large diameter tool set is empty(for display)
T—working time T / C—Number of working times
Decide the current life time, the maximum life time, life time prediction, unit of timing and
number of time.
R—effective value / - —non effective value.
Current tool are using tool management or not.
Current Life time