Syntec 60CB - TCP;IP Network Protocol Settings

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
How to Operate 60 Series Controller– 126
5.
•
remember these setting contents to use later on when setting controller.
TCP/IP setting

"Start" => "Setting" => "Network connections" and right click on "Properties", and select "Internet
Protocol [TCP/IP]"
Jumper cable (without HUB), select "use the following IP address" and enter IP address (the forth
number is different from controller setting) and Subnet mask (same with controller setting)