机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
How to Operate 60 Series Controller– 138
3.
•
•
•
"Workgroup", remember these setting contents to use later on when setting controller.
TCP/IP Setting
Double click "Internet Protocol Version 4 (TCP/IPv4)"
Jumper cable(without HUB), select "use the following IP address" and enter IP address(the forth
number is different from controller setting) and Subnet mask(same with controller setting)
Network cable(with HUB), select "Obtain an IP address automatically"
To Next Page
Loading...