Syntec 60CB - Page 27

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 27
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
i.
ii.
iii.
iv.
v.
vi.
•
•
•
•
•
End Line
Command
5 Buttons: F2 Program→Next→F2 Block Copy→F2 End Line
8 Buttons: F2 Program→F5Block Copy→F2 End Line
Function
Define the end line of block.
Block Cut
Command
5 Buttons: F2 Program→Next→F2 Block Copy→F3 Block Cut
8 Buttons: F2 Program→F5Block Copy→F3 Block Cut
Function
Cut the block that had been selected.
Block Copy
Command
5 Buttons: F2 Program→Next→F2 Block Copy→F4 Block Copy
8 Buttons: F2 Program→F5Block Copy→F4 Block Copy
Function
Copy the block that had been selected.
Block Paste
Command
5 Buttons: F2 Program→Next→F2 Block Copy→F5 Block Paste
8 Buttons: F2 Program→F5Block Copy→ F5 Block Paste
Function
Paste the block that had been 「Block Cut」and「Block Copy」.
Operation Method
Move the cursor to the desire line and press「Start Line」and function key「End Line」enable.
Press【↑】【↓】【Page Up】【Page Down】 to select desired area.
Press「End Line」,block between「Start Line」and 「End Line」will be selected.
→Function key 「End Line」disable.
→Function key 「Block Copy」enable.
→Function key 「Block Cut」enable.
→If 「Block Cut」being use, the whole block that had been highlight will be cut off.
→Function key 「Block Copy」/「Block Cut」disable.
→Function key 「Block Paste」enable.
Move the cursor to the desire location and press 「Block Paste」, the content that had been cut or
copy will paste at the cursor location.
If 「Block Copy」is used, the block that had been selected will not disappear.
Note
If 「Block Cut」is use, and do not paste the content immediately, the cut program will disappear.
The contents of「Block Cut」can be pasted for only one time but the contents of 「Block Copy」 can
be pasted for many times.