Syntec 60CB - Page 49

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 49
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
F5：Tool Wear Set
Function：Show the tool wear set screen
ARM machine：Tool Wear Set and Information are at the same fenubar layer, the tool wear set page can
be opened by pressing the fenubar and closed by pressing again (switch back to the Information page)
F6：Start MPG Shift
Function：Enable the MPG Shift function
F7：
5 key, 8 key：Work Record
Function：Show the work record
10+8 key：Graph Adjust
Function：
  
F8：
5 key, 8 key：Clear Accum. Cycle Time
Function：Clear the accumulated machining time to zero
10+8 key： File Manager
Function：
F9：
5 key, 8 key：N/A
Function：N/A
10+8 key：Work Record
Function：Show the work record
  
F10：
5 key, 8 key：N/A
Function：N/A
10+8 key：Clear Accum. Cycle Time
Function：Clear the accumulated machining time to zero