机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
•
•
•
•
•
•
Item Content
Software Function Limit These G-code are not supported for 60CA/60CB
G1084: // fasttapping G code
G5: // HPCC mode
G5001: // path smooth mode
G5005: // disable learning control
G5006: // learning start
G5007: // enable parameter learning control
G6: // Parabolic Interpolation
G6002: // nurbs G code
G7001: // G07.1(G7001) cylinder programming
G22: // stored stroke check function on
G23: // stored stroke check function off
G33: // Constant Thread Cutting
G34: // Variable Thread Cutting
G41: // Cutter Compensation Left
G42: // Cutter Compensation Right
G45: // tool offset
G46: // tool offset
G47: // tool offset
G48: // tool offset
G50: // scaling cancel
G51: // scaling
G52: // local coordinate setting
G61: // exact stop mode
G62: // cutting mode
G62002: // S-Curve mode
G63002: // EDM mode
G74: // left-hand tapping
G76: // fine boring cycle
G81001: // chopping start
G84: // tapping cycle
G87: // accurate boring cycle
G88: // boring cycle
G89: // boring cycle with dwelling at bottom
G93: // 1 / time(min), inverse time feed
G96: // Constant Surface Speed
G97: // Revolution per minute
G900081: // fast drilling
Standard Support T-code and T0000 from T0~T16
WorkingList
Plugin Enable ( Option-4 )
Pr4070 ( Default Feedrate )
SRI setting screen for FC-IO
To Next Page
Loading...
Need help?
General
