Syntec 60CB - MMI Configuration and Defaults

机床产品/Machine Tool Products – 60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction– 63
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Set MMIConfig
Path
5 key, 8 key:F5 Maintain → F5 Sys. Setting → F8 Set MMIConfig
10+8 key: G5 Maintain → F5 Sys. Setting → F8Set MMIConfig
Explanation
This page is used for other system environment setting. ( 9 pages in total )
Operation Method
Move the cursor with【↑】【↓】【←】【→】
Switch pages with【PageUp】【PageDown】
Set Default
Path
5 key, 8 key:F5 Maintain → F5 Sys. Setting → F8 Set MMIConfig → F4 Set Default
10+8 key: G5 Maintain → F5 Sys. Setting → F8 Set MMIConfig → F4 Set Default
Explanation
Reset the value of where the cursor is located to default
Attention
The setting only takes effect after reboot
Set Default All
Path
5 key, 8 key:F5 Maintain → F5 Sys. Setting → F8 Set MMIConfig → F5 Set Default All
10+8 key: G5 Maintain → F5 Sys. Setting → F8 Set MMIConfig → F5 Set Default All
Explanation