SYNTHES 3
DHS Locking Device (280.960)
The DHS locking device is used together with the
DHS for temporary locking of the sliding mechanism of
the DHS/DCS screw.
– Steel
– Inner hexagon for DHS Torque-indicating Screwdriver
338.560
– Length: 35 mm
DCS Plates (281.900–990)
– Steel
– Fixation with cortex screws 4.5 mm
– Lengths: 114–370 mm (6–22 holes)
– Thickness: 5.4 mm
–Width: 16 mm
– Hole spacing: 16 mm
– Barrel length: 25 mm
DHS/DCS Screws (280.000–950)
– Steel
– Lengths: 50–145 mm
– Thread diameter: 12.5 mm
– Thread length: 22 mm
– Shaft diameter: 8.0 mm
DHS/DCS Compression Screw (280.990)
The compression screw is used together with the DHS
and DCS plates.
It is used in pertrochanteric fractures to compress
the femoral fragments on the proximal and distal sides of
the fracture.
The DHS/DCS compression screw must be used if a DCS
plate is applied to the distal femur.
– Steel
– Inner hexagon for Hexagonal Screwdriver 314.120 and
314.270
– Length: 36 mm
To Next Page
Loading...
