SYSMEX SP Series - Stain Only; Auto Sampler Mode (Standalone)

Document Ref: SUKBMS-24-
601
Version: 2.0
Page | 27
Date: 19/07/2021
Classification
Unrestricted
To perform stain only place manually prepared place the
manually prepared slides in the single cassettes on the
cassette supply table.
Place a maximum of 5 racks on the right hand side of the sampler
unit and from the main menu select [Sampler]. Press [Start]. NOTE:
If system is not connected to a host then samples will need to be
registered on analyzer prior to analysis
Stain Only
Auto Sampler Mode (Standalone)