SystemAir Danvent DV - 12.3 AC-fan operation without thermistor for Danfoss FC101


Annex12—4

12.3AC‐fanoperationwithout thermistorforDanfossFC101.
Systemairfactoryset‐upisbasedonDanfossinitialization.
14‐22:Operationmode: [2]Initialisation(DanfossInitialisation)
Turnpoweroffandon.
Systemairfactoryset‐up:
0‐01:Languageselection:
1‐03:Torquecharacteristic:
 [3]Auto‐Energyoptim.
1‐20:Motorpower: Accordingtomotorplate
1‐24:MotorCurrent: Accordingtomotorplate 
1‐25:MotorNominalSpeed: Accordingtomotorplate
1‐29:Automaticmotoradption(AMA): [1]Kompl.motoradaptionto(Turnpoweroffandon.)
1‐42:MotorCableLeng th: 
Orderspecific
1‐50:
MotorMagnetisationatzerospeed.: 0%
1‐52:Min.SpeedNormalMagnetisation: 10Hz
1‐73:Flyingstart:  [0]Deaktivated
5‐40.0:FunctionRelay:  [3]Driveready/remote
14‐03:Overmodulation:  [1]Active
14‐20:ResetMode: [2]Automaticresetx2
0‐50:LCPCopy: [1]AlltoLCP(CopyofSystemairfactorysettingstopanel)
Connections:
0‐10V:  terminal54‐55

Start:  terminal12‐18
Driveready:  terminal1‐2

Jumper terminal12‐27
 