SystemAir SAVE VSR 500 How-To

PAGE 4
4
SAVE VTR 100/B
5
SAVE VTR 150/B
6
SAVE VTR 150/K
When it’s time to change the lters an alarm is shown on the
control panel display. When this occurs do the following:
When it’s time to change the lters an alarm is shown on the
control panel display. When this occurs do the following:
When it’s time to change the lters an alarm is shown on the
control panel display. When this occurs do the following:
1. Stop the unit by disconnecting the mains.
2. Open and remove the side cover.
3. Pull out the lters towards you. Some force may
be needed.
4. Insert the new lters. Make sure that the correct
lter types are inserted. See note above.
5. Close and fasten the side cover and connect the
unit to mains.
6. Reset the lter time.
1. Stop the unit by disconnecting the mains.
2. Open and remove the side cover.
3. Pull out the lters towards you. Some force may
be needed.
4. Insert the new lters. Make sure that the correct
lter types are inserted. See note above.
5. Close and fasten the side cover and connect the
unit to mains.
6. Reset the lter time.
1. Stop the unit by disconnecting the mains.
2. Open the front hatch.
3. Pull out the lters towards you. Some force may
be needed.
4. Insert the new lters. Make sure that the correct
lter types are inserted.
5. Close and lock the front hatch and connect the
unit to mains.
6. Reset the lter time.

SystemAir SAVE VSR 500 Specifications

General

Brand	SystemAir
Model	SAVE VSR 500
Category	Fan
Language	English