Service
|
29
6.2.1.9 Overheat protection reset button
If the supply air temperature is low, it can indicate that the over heat protec-
tion is triggered. The overheat protection can be reset by pressing the reset
button .
The button is placed on the top cover.
1. Reset button
6.3 Electrical connections
The SAVE VSR 300/500 is wired internally from factory.
The electrical connection box is on top of the unit behind
a cover plate.
1. Main print card
6.3.1 Main board layout
The SAVE VSR 300/500 is equipped with built-in regulation and internal wiring.
The figure shows the main circuit board. See wiring diagram for more information.
| v1_1.12.0
To Next Page
Loading...
