TAC AB, Feb 2000
4:13
Special functions, P:16 -
TAC 200 User’s Manual
4.12 Test functions
There are a number of test functions to check the display, the relay outputs etc.
To see what program version is loaded, use
P:60 Program version no. x.xx
The current version of the program is shown on the display.
The four relay outputs can be controlled directly from the panel (+ : on, – : off)
when the following functions are used.
P:61 Manual control of output K1
P:62 Manual control of output K2
P:63 Manual control of output K3
P:64 Manual control of output K4
The requested output is shown on the display: 1 : on, 0 : off.
The manual control is only in action as long as the controller is in actual
position. If the key ( on (+) or off (–)) has not been touched for more than 2
minutes the display return to 00 and the controller takes normal control of the
output again.
With the function
P:65 Test the display
you can turn on (+) and off (–) all the segments of the display.
Note!
To Next Page
Loading...
Need help?
General
