TAC AB, Feb 2000
1:1
Introduction
TAC 200 User’s Manual
1 Introduction
1.1 The TAC 200 Heating Controller
The TAC 200 is a controller for different heating systems.
TAC 200 may be operated with or without a room sensor.
It also compensates for the outdoor temperature in different ways.
The controller has an easy-to-use operator interface and needs virtually
no maintenance.
1.2 This manual
This manual has the following contents.
Chapter 2
Shows how the TAC 200 is mounted, connected and commissioned.
There is also a description of the operator interface with its symbols. To
show the usage of the operating keys, there is a detailed description on
how to set the date and time.
After the time has been set, the TAC 200 immediately starts working with
default values.
Chapter 3
This chapter describes the daily operations on the TAC 200. You can
read temperature values, enter setpoint values and change the time
programs for day and night time operation.
Chapter 4
When a plant is commissioned and fine-tuned, it may be necessary to
adjust some of the parameters. The controller function and available
parameters are described in chapter 4.
Chapter 5
This is a summary of the technical data of the TAC 200. There is also a
list of all the default values used at a restart.
At the end of the manual there is a commissioning protocol, where
entered values should be noted.
To Next Page
Loading...
Need help?
General
