NB/NHB Series Technical Manual
Installation
Place the scale on a table..
Connect the adaptor pin in to the scale adaptor jack. Adaptor jack is locating,
rear side of the scale.
Adaptor connects into your AC power socket. Pluggable equipment must be
installed near an easily accessible socket outlet with a protective ground/
earth contact.
Turn on the On/Off key. If you want to turn off, press the key again.
Display will be show the version number and will be starting self checking.
After self checking, display will be come to normal weighing mode.
Warm-up time of 15 minutes stabilizes the measured values after
switching on.
Calibrate with exact calibration weights, minimum 1/3 of the scale capacity want
to use for calibration. For calibration, see details in parameter.
Then you can start your operation
To Next Page
Loading...
Need help?
General
