NB/NHB Series Technical Manual
4. INSTALLATION
Unpacking
Carefully take the balance out of its package, make it sure its not damaged and all
accessories are included.
Remove the weighing scale from the carton.
Remove the protective covering. Store the packaging and to use if you need to
transport the scale later.
Inspect the scale and terminal for damage.
Make sure all components are included
Accessories,
Level Adjusting
Place the scale on a table.
Check the water mark. If, bubble is not centre adjust
the leveling feet until reach centre. Check the level
when you change the location.
Charging Battery
To charge the battery insert the adaptor pin to jack, jack is locating rear side of
the scale. Adaptor simply plug into the mains power. The scale no needs to be
turned on.
The battery should be charged for 12 hours for full capacity.
In the LCD display has an battery indicator to indicate the status of battery
charging, When the scale is plugged into the mains power the internal battery
will be recharged. When turn on the indicator ,if the battery indicator is full then
the battery has a full charge. If it is half then the battery is nearly discharged
and empty indicates the battery should be charged.
Do not use any other type of power adaptor than the one supplied with the scale.
Verify that the AC power socket outlet is properly protected.
Note: Please charge the battery before using the scale for the first time
To Next Page
Loading...
Need help?
General
