AR-G2/AR 2000ex/AR 1500ex Getting Started Guide Page 35
The Environmental Test Chamber (ETC)
The ETC is a high temperature Smart Swap™ option available for the AR-G2 and AR 2000ex rheometers.
It uses a controlled convection / radiant-heating concept and has a temperature range of –160 to 600°C
with heating rates up to 60°C/min. The unique design of the ETC provides fast response and temperature
stability over a continuous 760°C range as highlighted in the figure below with temperature steps of 20°C.
The ETC is a very popular option for polymer applications and can be used with parallel plate, cone and
plate, disposable plate, and rectangular torsion clamps for solids. Typical materials that can be tested
include thermoplastics, thermosets, elastomers, caulks and adhesives, solid polymers, asphalt binder, and
oils and greases.
Refer to the ETC
Getting Started Guide for additional information.
Figure 14 AR Series ETC.
To Next Page
Loading...
